Square crossflow cooling tower
The MDHZ cross-flow FRP cooling tower adopts air inlet on both sides, and the fan at the top makes the air exchange with the hot water through the packing on both sides of the tower, and the hot and humid air is discharged to the outside of the tower. The filler adopts a wave plate with bumps on both sides, and the wave plate is bonded into the whole through the mounting head to improve the rigidity. The bumps on both sides can also avoid direct dripping, thereby improving the water film forming ability, and the tail of the packing is provided. Water measures.
Product features:
1, save space, light structure
The high-efficiency heat exchange packing designed for this series of cooling towers greatly improves the heat exchange area. Compared with the original HBLD series and the original HBLCD series, the floor space is greatly reduced due to the optimization of the structural design and the use of steel structures. The running weight is also greatly reduced.
2, save electricity
It uses a small ventilation resistance and a wing-type FRP high-efficiency fan designed by Tsinghua University for the cooling tower to reduce the power of the motor. The ultra-low noise type uses less motor power and saves power. According to the user's request, a two-speed motor is used to save power.
3, running noise is extremely low
The low-noise axial flow fan designed by Tsinghua University for the cooling tower and the low-noise motor designed for the cooling tower reduce the running noise of the cooling tower. Ultra-low noise series cooling towers operate at lower noise levels and are fully environmentally friendly. If a two-speed motor is used, the noise can be further reduced by 2-3dB (A) during low-speed operation at night. The user needs the two-speed motor to be separately requested when ordering.
4, good corrosion resistance
The tower body, the water tank and the panel are all made of FRP material with good corrosion resistance, and a light stabilizer is added to the gel coat resin, which has good anti-aging properties and does not change color over time. The tower steel structural parts are galvanized after processing to improve the corrosion resistance of the cooling tower, and no additional corrosion protection is required during the normal service life.
5, convenient combination
The combination method can be used to meet the requirements of different working conditions, and the user can also make a decision combination according to the site conditions, and can adjust the appearance of the cooling tower according to the characteristics of the user's building. If the user's venue is very limited. Our company can also design according to the special requirements of users to meet the requirements of users for thermal performance and noise.
6, easy to maintain
This series of cooling towers is a combined design. The adjacent cooling tower air chambers are separated from each other. Under the premise of normal operation of the cooling tower, maintenance and overhaul can be carried out. It is more convenient to clean the packing, water mains and water tank.
Note: 1. The tower type with (*) can be connected in parallel according to the requirements, not limited to this table; 2. The weight of the ultra-low noise cooling tower is increased by 5%.
